|
|
| |
|
|
|
|
|
|
 Click to enlarge image
|
HIFLEX METAL GASKET consists of graphite, metal
- O-ring, metal clad, hoop and filler or corrugate metal, which are formed one body.
- As a result of this, it shows a broad sealing width, improvement of sealing capacity and sufficient elasticity in high load compared with spiral wound gasket in same size.
- It is also possible to install in narrow part except the guide ring for centering.
CONSTRUCTION
GRAPHITE
- Complement the damaged sealing surface
- Improve on the sealing characteristics.
METAL CLAD
- Prevent the oxidation of filler and hoop
- Restraint the gasket's expansion after compression.
METAL O-RING
- Improve the recovery of the gasket and complement sealing properties by the absorption of the expansibility in the in
- out diameter direction.
FILLER & HOOP/CORRUGATED METAL
- Maximize the sealing property in the high temperature and pressure
- Maximize the thickness tolerance by the new design to improve the recovery and the pressure restraint of the conventional Non-Metallic filler material.
① HIFLEX G-21
- The form of spiral wound gasket in used
- The form of spiral wound gasket in used is a new design,
- W-Type structure, and this enlarges the sealing effect in high temperature, high pressure and condition of a thickness deviation.
② HIFLEX G-22
- The form of corrugated metal in used
- Corrugated Metal is one of versatile seal products
- where the available bolt loads are low.
- Depending on the materials and construction, it can be very resilient.
Characteristics
- High pressure application
- High resistance especially against corrosive substances and chemicals
- Conformity where low bolt stress is available
- High elasticity
- High sealing performance
- Stability of compressibility & recovery
- Semi-Permanent
- No hazard to health
Application
- Steam and Hot Water
- Water and Brine
- Air and Hot Air
- Heat Transfer Liquids
- Ammonia
- Hydrogen Gas
- Hydrocarbon
- Volatile Organic Compounds
Service Temperature
Working Pressure
Test conditions
The Leak Test conducted our laboratory shows the result.
- Gasket Factor - m = 3.75 - y = 9000 psi
- Test Fluid : Helium
- Test Pressure : 30 Kgf/cm2
- Test Temperature : Room Temp.
Test Result
- Compression: 16.7%
- Recovery: 85.9%
- Spring Bank: 14.7%
Reliability and Long Life
This we ensure because of the care taken in our manufacturing program, rigid quality control standards, the best craftsmen and highest quality materials. HIFLEX METAL GASKET will meet your requirements.
|
|
|
|
| |
|
|
|
Related Keywords:
Bookmark / Share this page